Standard CD Studs

Flanged Capacitor Discharge

STUD D FD Min L 3mm 5mm 10mm 4mm 6mm 6mm 5mm 6mm 8mm 6mm 8mm 10mm 8mm 10mm 8mm Low Carbon Steel c-0.23% max Mn-0.60% max P-0.04% max S-0.05% max Stainless Steel AISI grade-304 Other grades available on request Aluminium Alloy-1100 & 5086 std Other alloys available on request Mechanical Properties Tensile 75,000psi (max) Yield 64,000psi (max) Elongation 21% (in 2 inches) Values for various grades available upon request Values for various alloys available upon request

Standard Insulating Pins

PINS D C LENGTH .105 5mm as required Material Mild Steel, Stainless steel 304, Aluminium Plating Zinc plating, Standard on mild steel pins Annealing Available on request Speed Clips Self locking speed clips are available in a variety of sizes and material up to 2.1/2" square

Drawn Arc Studs

Threaded Studs	Material Low Carbon Steel c-0.23% max Mn-0.60% max P-0.04% max S-0.05% max Stainless Steel AISI grade-304 Other grades available on request Mechanical Properties Tensile 75,000psi (max) Yield 64,000psi (max) Elongation 21% (in 2 inches) Values for various grades available upon request
Headed Concrete Anchors	Shank diameter (d) Length tolerance (L) Head diameter (HD) Minimum head height (HT) 12.7 +0.00 -0.25 + -1.6 25.4 + -0.4 7.1 15.9 +0.00 -0.25 + -1.6 37.1+ -0.4 7.1 Low Carbon Steel c-0.23% max, Mn-0.60% max, P-0.04% max, S-0.05% max Mechanical Properties Tensile 75,000psi (max) Yield 64,000psi (max) Elongation 20% (in 2 inches)
Ferrule	Headed Concrete anchors are available for welding to flat surfaces, inside angles and outside angles. Each of these applications requires the proper style of stud and ferrule, so please specify your application when ordering studs. Ferrule exterior dimensions available on request.
NOTE: Ferrules are component parts of studs. NOT SOLD SEPARATELY
Shear Connector	Shank diameter (d) Length tolerance (L) Head diameter (HD) Minimum head height (HT) 19.0 +0.00 -0.38 +-1.6 31.7 +-0.4 9.5 22.2 +0.00 -0.38 +-1.6 34.9+-0.4 9.5 Low Carbon Steel AISI, C1015, C1018 or C1020 Mechanical Properties Tensile 60,000psi (min) Yield 50,000psi (min) Elongation 20% (min) Reduction of are 50% (min)

REFRACTORY ANCHORS

If you want to secure blanket, castable or gunited refractory material and you want to keep costs down, then you need refractory anchors. They offer lower in-place costs than any other similar products on the market today. Designed to meet the requirements of your job, whether it is large or small, they are available for either stud welding or hand welding.