For lapped, horizontal x-style connections For cable-to-cable X-style connections at power sub-stations and other commercial and industrial sites, there’s never been a faster or easier way to make a reliable CADWELD connection.

This new two-piece mold lets you make connections in a trench in about half the time it would take with compression connectors or other exothermic products — and at a fraction of the cost.

• Ergonomic two-piece molds use standard L160 and L159 handle clamps -the same clamps you use with other CADWELD molds.
• Saves labour costs. X-style connection can be made by one person in about 1 minute. That’s 40 to 70% faster than other methods.
• Costs less. Saves you 1/3 over other models, thanks to innovative design techniques and advanced manufacturing technology.
• Simple to use. Operates just like an XA-style mold, but there’s no need to cut the cable!
• Easy cable alignment.
• Also available in “smoke less” EXOLON ®

Position clean, dry cables in mold and clamp closed.		Insert disk, pour weld metal and starter material into crucible, and ignite to form the weld.		Remove finished connection. Clean mold.